You searched for "pin"
100 FAQs Found
Page 1 of 10
Will a Bushmaster upper receiver match up with my Colt lower?
Is there a flip front sight I can install in place of the Front sight tower on the Patrolman's carbine? If there is, how can I remove the old Front sight? Is there something I can cover the pin slots with ?
Will you be developing a Gas Piston Operating System in 6.8 SPC?
I was checking the cartridge feeding on my AR recently by chambering rounds by hand, and I noticed afterwards that the primers on the cases were slightly marked by the firing pin (very slightly and every bullet). I assume the firing pin should not protrud
Do you still sell any parts for the M17S? Particularly small parts, pins & springs.
I have two different style bolt carriers in my two Bush AR15's One has the covered firing pin and the other open. Which is better and why?
I bought a Bushmaster AR-15 V-Match A3 Upper Assembly 223 Remington 1 in 9" Twist 20" Barrel Chrome Moly Matte Pre-Ban from Midway USA. I was wondering what parts I need to buy so I can install and Harris Ultralight bipod since there is no swivel pin on the bottom. Thanks for your help! Thanks, Jonathan
While smy firsthooting my Varminter yesterday, a friend offered me to shoot some of his handloads....and my first round got stuck while bolt was closing...appears to be almost or completely closed. I CAN NOT PULL THE BOLT CARRIER BACK, IT IS STUCK TOO. tHIS IS A LIVE ROUND. I also tried to break the gun apart after pulloing the retaining pin out and it will not separate..the lower from the upper. Obviously this round was not fully resized to sami spec's. Now what do I do?
I just purchased a Bushmaster 308, #BAR 002236 that appears to have been used very little. I would like to get all the Tech Spec's on this model i.e. Chrome lined barrel, etc... and would like to know if the muzzle brake is pinned & welded and the history of and how many of the BAR 308's were made before you discontinued the model? I would also like to know if you still have any spare parts like Bolts, Carriers, springs etc....and if not who would have the parts? This one appears almost new and I would guess less than 50 rounds have been fired by the looks of the bolt etc... I have heard the rumors of bolts breaking and other problems with feeding, how true are any of these? Thanks for any and all help with this information and your time. Robert
Do you have to remove the front sight from the barrel to install a V-match hand guard?
Go to Page :
Can't Find an Answer?
If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.