Search Results

You searched for "manual"

38 FAQs Found Page 1 of 4
	What parts break most often on the AR15? - and why?
	While zeroing in my new Bushmaster 20" XM15 E2S, I noticed a difference between what the Technical Manual said and what was happening with my rear sight. According to the manual, the sight should go down three clicks beyond the 300 meter setting and bottom out. Mine bottomed out at the 300 meter setting. Which is correct, the Manual or the factory setting of the rear sight? 2nd Q. My Operator's Manual that came with my rifle says that to zero my rifle at 25 meters (page 53), my range scale should bottom out at three clicks past the 8/3 mark, while my Technical Manual (page 3-57) says the scale should bottom at 8/3. What's up with that?
	With a loaded clip you pull the charging handle back and the bottom half of the bolt carrier is grabbing the bullets in the clip and angling the bullets up out of the clip, and sometimes they will chamber correctly and the gun will fire, other times the bullet will go into the chamber and bend the bullet and it will not fire and it is jammed in the chamber, or other times it will pop up and get jammed between the charging handle and the bolt carrier. It does this whether manually or if it is cycling through the action as supposed to.
	I recently purchased my first AR a Bushmaster MOD XM15-E2S with no owners manual from Cabelas is the DELUXE ARMORER'S TOOL KIT Part No: A1 DARM KIT. The The Bushmaster DVD part No: ADS-002 AR15/M16 Handguard Removal Tool Part No: HGD-TOOL Adaquate for basic service andmaintance? I have cleaning supplies. Last do I have an A1 or and A2? What is A1,A2? Thank you for your time and consideration
	This is a reloading question. Most of my manuals only list the .223. For a long time I assumed this meant bolt guns and gas guns. Recently Sierra and Hornady have listed a separate section for each category. I would like your thoughts on whether to keep velocity around 28-2900 fps or will it damage the gun to load it to the full potential of the .223 cartridge say with a 55 grain bullet? Also, I believe the info in all the reloading manuals is for loading commercial brass. Where would you reccomend starting the powder charges when loading military brass. I don't shoot anything but reloaded ammo in all of my weapons, be it handgun, rifles or shotguns.
	HOW DO I REMOVE THE STOCK TELESTOCK ON A2007 BUSHMASTER ORC THE MANUAL DOES'NT SHOW THE PROCEDURE .I WANT TO UPGRADE TO A COMMERCIAL TUBE MAGPUL CTR/MOE TELESTOCK. SINCE YOU ARE ABOUT TO PRODUCE A WEAPON SYSTEM WITH MAGPUL WILL YOU BE ADDING SOME OF THEIR ACESSORIES TO YOUR CATALOGUE.
	I just purchased a XM15-E2S. It is stamped such on the lower receiver. It has the A1 type rear sight (no elevation adjustment) instead of the A2 type referred to in the manual it came with. Did Bushmaster market two versions of the E2S model? If not, might have the dealer I purchased this one from change the upper receiver with an older model? Can I replace the upper receiver with an A2?
	I purchased a used rifle and need to know what the specs are. How do I tell if the barrel is chrome lined. Mod. XM15-E2S Barrel stamp B MP 5.56 NATO 1/9 Also can I get an owners manual for this gun?
	SUPPLEMENTAL INFORMATION TO THE BUSHMASTER OPERATING AND SAFETY INSTRUCTION MANUAL FOR THE GAS PISTON RIFLE AND UPPER RECEIVER ASSEMBLY.
	How can I get an owners manual for my ( BANNED ERA ) XM15-E2S ?
Go to Page : 1234

Can't Find an Answer? If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.